To start up
CenterStage, first start
Geomview, and click (once) on the
CenterStagename listed in the external modules selector at the bottom right of the main
Geomviewcontrol panel. After a few moments, you should see the CenterStage window open, and some initialization messages will appear at the bottom. When the menu names become active (black instead of grey), you are ready to begin.
If you get error messages about commands not being found, check that you followed the installation instructions correctly. In particular, be sure that you ran the
wish fixcommand in order to tell
StageToolsthe location of the TCL/TK commands. If you did that, then check the file permissions on the commands in the main
StageToolsdirectory and in the various
modulesdirectories to be sure that the execute bit is set. Also, check the permissions on the directories to be sure that you have read access to them. You may need to restart
Geomviewafter making some changes.